Introduction

The Dyson brushbar power button is located in between the handle and the dust bin on the front of the vacuum.

Parts

No parts required.

  1. Gently pull up on red handle to separate the hose from the external hose of the Dyson.
    • Gently pull up on red handle to separate the hose from the external hose of the Dyson.

    Add Comment

  2. Locate the 18mm four screws on the Dyson above the sticker.
    • Locate the 18mm four screws on the Dyson above the sticker.

    Add Comment

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Unscrew the four 18mm screws.

    Add Comment

    • Locate and push the grey button (where the index finger is pointing) while simultaneously pulling up on the handle.

    Add Comment

    • Pull on the plastic case below the power and brush bar buttons to separate it from the Dyson.

    Add Comment

    • Slide the buttons out from the case and replace.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Karla Sunjara

Member since: 01/24/2017

649 Reputation

5 Guides authored

Team

Cal Poly, Team S13-G1, Banghart Winter 2017 Member of Cal Poly, Team S13-G1, Banghart Winter 2017

CPSU-BANGHART-W17S13G1

3 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 6

Past 30 Days: 27

All Time: 719