Fix Your Stuff Community Store

Dynex DX-WBRDVD1 Top Cover Replacement

Introduction

This is the guide to crack into your device, almost every repair guide will need this completed first before being able to tear into the hardware below.

What you need

  1. Dynex DX-WBRDVD1 Top Cover Replacement, Top Cover: step 1, image 1 of 2 Dynex DX-WBRDVD1 Top Cover Replacement, Top Cover: step 1, image 2 of 2

    • Remove the four 5mm Phillips #1 screws that connect the black outer shell to the silver back of the device.

    Edit

  3. Dynex DX-WBRDVD1 Top Cover Replacement: step 2, image 1 of 1

    • Remove the two 5mm screws on the left and right side panels.

    • There is one screw on each side that secures the cover to the body of the device.

    Edit

  4. Dynex DX-WBRDVD1 Top Cover Replacement: step 3, image 1 of 1

    • Lift the black cover to a 45 degree angle from the rear of the device and pull the cover away entirely.

    • Check that the power cord is not preventing the device from opening or closing.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 5

All Time: 140