Remove the six 13 mm casing screws with the #0 Phillips screwdriver.
  • Remove the six 13 mm casing screws with the #0 Phillips screwdriver.

Add Comment

Separate the screwdriver casing halves with the plastic opening tool. Separate the screwdriver casing halves with the plastic opening tool.
  • Separate the screwdriver casing halves with the plastic opening tool.

Add Comment

Slide the bit chuck assembly out from the casing half.
  • Slide the bit chuck assembly out from the casing half.

Add Comment

Apply a dab of grease to the end of the drill motor coupler.
  • Apply a dab of grease to the end of the drill motor coupler.

Add Comment

Insert new bit chuck assembly into the drill casing.
  • Insert new bit chuck assembly into the drill casing.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Tyler Vincent

Member since: 02/24/2014

401 Reputation

4 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 3

All Time: 255