Introduction

This is a simple repair for your heat gun that can be accomplished by any level of DIY skill. Just be sure to have the listed tools and, of course, don't have your heat gun plugged in.

Image 1/1: Remove the seven 14mm screws from the side of the drill using the PH#0 screwdriver.
  • Be sure the heat gun is unplugged before starting this process.

  • Remove the seven 14mm screws from the side of the drill using the PH#0 screwdriver.

  • You will need a screwdriver extension.

Add Comment

Image 1/1: Don't try to open the casing just yet.
  • Remove the 8mm screw from underside of barrel using the PH#0 screwdriver.

  • Don't try to open the casing just yet.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • Remove the barrel casing on either end by twisting and pulling each side off.

Add Comment

Image 1/1:
  • Remove the top casing to reveal inside of drill. You might have to tug a little harder for this one.

Add Comment

Image 1/1: Screws do not come out of connector.
  • Loosen four screws on the wire connector using the flathead 2.5 screwdriver.

  • Screws do not come out of connector.

Add Comment

Image 1/1:
  • Disconnect the power cord wiring from the wire connector.

Add Comment

Image 1/1:
  • Remove the two 12mm screws from the base of power cord using the PH#0 screwdriver.

Add Comment

Image 1/1:
  • Remove the power cord from the heat gun.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Mikayla Kim

Member since: 01/31/2017

501 Reputation

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 6

All Time: 48