Dremel MultiPro 395 Casing Replacement

Step 1 Casing



• Remove the blue caps located on either side of the MultiPro, using a 3 mm flathead screwdriver.
Step 2



• Carefully remove the carbon brushes attached at the end of the springs by gently pulling on the springs using your hands.
Step 3
• Pull one side of the hanger up and then pull away from the Multipro until the other side can be pulled out.
Step 4
• Remove the 4 screws located on the bottom of the Multipro with a T15 screwdriver.
Step 5
• Hold down the collet lock, remove the chuck cap from the top of the Multipro by screwing counterclockwise.
Step 6
• Remove the black housing cap from the Multipro located directly below the chuck cap.
Step 7
• Pull the bottom side of the casing up to remove it.
Step 8
• Gently lift the motor shaft out of the Multipro.
Step 9
• Pull the lock pin and its casing out of the other side of the Multipro case.

Author

with 4 other contributors

Matthew Satton

Member since: 09/17/14

520 Reputation

2 Guides authored

Badges: 15

• 
• 
• 

+12 more badges

Team

University of Kentucky Louisville, Team 1-5, Mathis Fall 2014 Member of University of Kentucky Louisville, Team 1-5, Mathis Fall 2014

LOUISVILLE-MATHIS-F14S1G5

5 Members

4 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview