What you need
-
-
-
The ADC and Logic board contains:
-
Bluetooth module
-
Power button connector
-
Battery and sync button connector
-
Strain gauge wheatstone bridge connections
-
The topmost connection for each of the four bridge connections is the ground; relative to this, the two middle connections should be at 1.2 VDC, and the bottom should be at 2.7 VDC
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
15 other people completed this guide.
5 Guide Comments
Can I take out the battery box without removing the bottom?
No, you can't. You will have to follow this procedure completely.
is there schematics for the power pcb
?