Introduction

For this guide you will remove six screws in order to remove the back cover.

Parts

No parts required.

Remove the calculator's protective cover. Place the calculator face down.
  • Remove the calculator's protective cover.

  • Place the calculator face down.

Add Comment

Using a Phillips #1 screwdriver, remove the six 6mm screws from the back of the case and place them to the side. Start from the notches on the top edge and use your fingers or a prying tool to carefully pry the back cover from the calculator.
  • Using a Phillips #1 screwdriver, remove the six 6mm screws from the back of the case and place them to the side.

  • Start from the notches on the top edge and use your fingers or a prying tool to carefully pry the back cover from the calculator.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Robert Sekerak

Member since: 04/25/2014

449 Reputation

4 Guides authored

Team

Cal Poly, Team 11-52, Amido Spring 2014 Member of Cal Poly, Team 11-52, Amido Spring 2014

CPSU-AMIDO-S14S11G52

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 11

Past 30 Days: 32

All Time: 612