Introduction
You will take apart the camera case to access the circuit board after removing the battery. Be ready to handle small parts and screws.
Parts
No parts specified.
-
-
To access the battery, gently pry open the rear cover of the action cam.
-
-
-
Using a pair of tweezers, firmly grip the protrusion where the PULL signifies and remove the tray and battery.
-
-
-
Open the bottom tab with your finger or a plastic opening tool.
-
Pull the tab out, not up, to remove it completely.
-
Remove the two screws indicated by the second photo.
-
Once the screws are removed, extract the plastic plate as shown in the third photo.
-
-
-
Separate the outer casing from the electronics by pushing on one of the ports toward the back end of the case. The electronics should slide right out.
-
-
-
Remove the two 1/4 in. Phillips screws on the LCD side of the device using a #00 Phillips head screwdriver.
-
Flip the LCD display downward to reveal the circuit board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.