Introduction

The front housing includes the motor, the chuck, and the gears. There's a good chance that whatever needs to be replaced will be found in here.

Parts

No parts required.

On the front of the drill, remove the three 2" flathead screws connecting the front housing to the rear housing.
  • On the front of the drill, remove the three 2" flathead screws connecting the front housing to the rear housing.

Add Comment

Pull the front housing apart from the rear. The motor and gears might fall out when you are pulling it apart.
  • Pull the front housing apart from the rear.

  • The motor and gears might fall out when you are pulling it apart.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Matt

Member since: 10/10/2010

365 Reputation

7 Guides authored

Team

Cal Poly, Team 5-17, Maness Fall 2010 Member of Cal Poly, Team 5-17, Maness Fall 2010

CPSU-MANESS-F10S5G17

3 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 80