Introduction

Shows how to open up the camera without damaging interior content.

Image 1/3: Image 2/3: Image 3/3:
  • To remove the wristband of the device, grab the middle loop and pull. Pull the band through as shown in the picture.

Add Comment

Image 1/2: Image 2/2:
  • Remove all four Hex screws with a Hex 1.5 mm screwdriver.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • To remove the HDMI screw, open the HDMI door on the side. Remove the screw using a Phillip size 00.

Add Comment

Image 1/3: Do not pry apart the device too hard. There is a wire that attaches the front case with the rear case. Image 2/3: Do not pry apart the device too hard. There is a wire that attaches the front case with the rear case. Image 3/3: Do not pry apart the device too hard. There is a wire that attaches the front case with the rear case.
  • As shown in the picture, use the plastic opening tool on both sides on the device. Pry apart both parts.

  • Do not pry apart the device too hard. There is a wire that attaches the front case with the rear case.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • Pull the wire ribbon out with a pair of tweezers.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Robert

Member since: 01/21/2015

867 Reputation

8 Guides authored

Team

USF Tampa, Team 9-2, Blackwell Winter 2015 Member of USF Tampa, Team 9-2, Blackwell Winter 2015

USFT-BLACKWELL-W15S9G2

4 Members

8 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 1

Past 30 Days: 13

All Time: 412