Introduction

Since this is step one, you will just need to start with your camera.

Parts

No parts required.

Image 1/1:
  • Remove the battery and memory card from the device.

Add Comment

Image 1/1: There are two 3.4mm screws at the top.
  • Remove 4 screws from the right side of the camera.

    • There are two 3.4mm screws at the top.

    • There are two 2.2mm screws at the bottom.

Add Comment

Image 1/1:
  • Remove the single 3.4mm screw on the left side of the camera.

Add Comment

Image 1/1: There are two 2.2mm screws next to the battery compartment.
  • Remove 5 screws from the base of the camera.

    • There are two 2.2mm screws next to the battery compartment.

    • There are three 4mm screws around the tripod mount.

Add Comment

Image 1/1: The back casing is held in place by two ribbon cables. Do not pull the back cover too far from the camera.
  • Slowly slide the back cover away from the device

    • The back casing is held in place by two ribbon cables. Do not pull the back cover too far from the camera.

Add Comment

Image 1/2: Use the tip of the spudger to lift the black clip upward, unlocking the ribbon cable. Image 2/2: Use the tip of the spudger to lift the black clip upward, unlocking the ribbon cable.
  • Detach both ribbon cables using a spudger.

    • Use the tip of the spudger to lift the black clip upward, unlocking the ribbon cable.

Add Comment

Image 1/1:
  • Remove the back casing from the camera.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 other people completed this guide.

Ben Canfield

Member since: 10/10/2010

358 Reputation

3 Guides authored

Team

Cal Poly, Team 9-21, Regan Fall 2010 Member of Cal Poly, Team 9-21, Regan Fall 2010

CPSU-REGAN-F10S9G21

4 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 4

Past 30 Days: 27

All Time: 5,768