Disassembling Optoma HD20 Cover

You're viewing a previously published version of this guide. View latest version

Nov 14, 2019 - 01:03:19

Nov 14, 2019 - 01:03:19 Mar 22, 2019 - 01:20:41 Mar 08, 2019 - 10:41:35 Dec 14, 2018 - 12:06:49 Jun 16, 2015 - 04:52:45 Jun 16, 2015 - 04:52:24 Mar 06, 2015 - 06:23:06 Mar 06, 2015 - 06:21:56 Mar 06, 2015 - 06:21:45 Mar 06, 2015 - 06:19:57 Mar 06, 2015 - 06:19:15 Mar 04, 2015 - 12:25:12 Feb 23, 2015 - 04:37:52 Feb 23, 2015 - 04:36:14 Feb 23, 2015 - 04:33:49 Feb 23, 2015 - 04:33:18 Feb 23, 2015 - 04:33:18 Feb 23, 2015 - 04:30:49 Feb 23, 2015 - 04:30:49 Feb 23, 2015 - 04:28:14 Feb 23, 2015 - 04:28:14 Feb 23, 2015 - 04:27:27 Feb 23, 2015 - 04:27:17 Feb 23, 2015 - 04:26:40 Feb 23, 2015 - 04:26:40 Feb 23, 2015 - 04:23:55 Feb 19, 2015 - 12:38:34

Newer

Introduction

Use this guide to remove the cover from your Optoma HD20.

What you need

Step 1 Disassembling Optoma HD20 Cover

Disassembling Optoma HD20 Cover, Disassembling Optoma HD20 Cover: step 1, image 1 of 2

Disassembling Optoma HD20 Cover, Disassembling Optoma HD20 Cover: step 1, image 2 of 2

Twist the focal cap clockwise until it is fully extended.
Remove the focal cap by pulling it straight out.

Step 2

Use a Phillips #1 screwdriver to remove the three 7.5mm screws on the bottom of the device.

Step 3

Use a plastic opening tool to gently pry the top cover off of the device.
It is easier to pry off the cover from the back side just above the HDMI ports.

Step 4

When removing the cover, be cautious of the ribbon connecting the top buttons to the main circuit board. The ribbon must be disconnected before proceeding.
Remove the ribbon by disconnecting it from the main circuit board.
Lift up the clip holding it down and pull the ribbon out.