Introduction

We will now disassemble the guts of the phone, including the SIM card reader, vibrating unit, power toggle button, audio speaker, power assembly/microphone, and the battery connector.

Parts

No parts required.

Hold the phone and push the white button with your thumb. While pressing the button, slide the back plate up (towards the top of the phone) and off the phone. While pressing the button, slide the back plate up (towards the top of the phone) and off the phone.
  • Hold the phone and push the white button with your thumb.

  • While pressing the button, slide the back plate up (towards the top of the phone) and off the phone.

Add Comment

Locate grey buttons beneath battery (shown). Spread buttons simultaneously away from each other and the battery will pop out.
  • Locate grey buttons beneath battery (shown).

  • Spread buttons simultaneously away from each other and the battery will pop out.

  • Remove battery from phone.

Add Comment

Where shown, spread the front faceplate and push forward. Flip over the device, and pry the faceplate away.
  • Where shown, spread the front faceplate and push forward.

  • Flip over the device, and pry the faceplate away.

Add Comment

Remove six T6 screws. Remove six T6 screws.
  • Remove six T6 screws.

Add Comment

Insert spudger between screen assembly and phone body. Spread apart as shown. Avoid damaging the screen assembly by removing the screen slowly.
  • Insert spudger between screen assembly and phone body.

  • Spread apart as shown. Avoid damaging the screen assembly by removing the screen slowly.

Add Comment

Remove logic board as shown. Remove logic board as shown.
  • Remove logic board as shown.

Add Comment

Use the following legend to locate each component:
    • Use the following legend to locate each component:

      • Microphone/power assembly.

      • Vibrating unit.

      • SIM card reader.

      • Audio speaker.

      • Power toggle button.

      • Battery connector.

Add Comment

Insert spudger between power assembly/micro-phone and phone body. Pry as shown and remove the power assembly/microphone.
  • Insert spudger between power assembly/micro-phone and phone body.

  • Pry as shown and remove the power assembly/microphone.

Add Comment

Once located, the following components are easily removed by pulling them out with your hand.
  • Once located, the following components are easily removed by pulling them out with your hand.

    • Microphone/power assembly.

    • Vibrating unit.

    • SIM card reader.

    • Audio speaker.

    • Power toggle button.

    • Battery connector.

Add Comment

Audio speaker. Audio speaker.
  • Audio speaker.

Add Comment

SIM card reader. SIM card reader.
  • SIM card reader.

Add Comment

Vibrating unit. Vibrating unit.
  • Vibrating unit.

Add Comment

Power toggle button. Power toggle button.
  • Power toggle button.

Add Comment

Battery connector. Battery connector.
  • Battery connector.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Nico Lee

Member since: 04/19/2010

54 Reputation

11 Guides authored

Team

Cal Poly, Team 30-41, Garner Spring 2010 Member of Cal Poly, Team 30-41, Garner Spring 2010

CPSU-GARNER-S10S30G41

4 Members

11 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 6

All Time: 2,711