Fix Your Stuff Community Store

Disassembling Nano 7/LINK (A/B/C-N Serial) Panels

Introduction

Removing the panelwork on any Kaffelogic Nano or Nucleus Link coffee roaster with an A, B, C or N prefix serial number.

What you need

  1. Disassembling Nano 7/LINK (A/B/C-N Serial) Panels, Removing Panel Screws: step 1, image 1 of 2 Disassembling Nano 7/LINK (A/B/C-N Serial) Panels, Removing Panel Screws: step 1, image 2 of 2

    • Remove the 6x 2.5mm Hex screws on the left and right side of the roaster.

    Edit

  2. Disassembling Nano 7/LINK (A/B/C-N Serial) Panels, Lift the closure: step 2, image 1 of 2 Disassembling Nano 7/LINK (A/B/C-N Serial) Panels, Lift the closure: step 2, image 2 of 2

    • Hold the roaster steady while removing the plastic top/closure.

    • Panels may spring apart slightly once removed.

    Edit

  4. Disassembling Nano 7/LINK (A/B/C-N Serial) Panels, Remove bottom panel screws: step 3, image 1 of 3 Disassembling Nano 7/LINK (A/B/C-N Serial) Panels, Remove bottom panel screws: step 3, image 2 of 3 Disassembling Nano 7/LINK (A/B/C-N Serial) Panels, Remove bottom panel screws: step 3, image 3 of 3

    • Remove the 4x 2.5mm Hex screws on the bottom of the roaster.

    Edit

  5. Disassembling Nano 7/LINK (A/B/C-N Serial) Panels, Remove the front panel: step 4, image 1 of 3 Disassembling Nano 7/LINK (A/B/C-N Serial) Panels, Remove the front panel: step 4, image 2 of 3 Disassembling Nano 7/LINK (A/B/C-N Serial) Panels, Remove the front panel: step 4, image 3 of 3

    • Pull away the front panel carefully.

    • Take care not to damage the buttons while maneuvering the front panel.

    Edit

  6. Disassembling Nano 7/LINK (A/B/C-N Serial) Panels, Remove rear panel: step 5, image 1 of 3 Disassembling Nano 7/LINK (A/B/C-N Serial) Panels, Remove rear panel: step 5, image 2 of 3 Disassembling Nano 7/LINK (A/B/C-N Serial) Panels, Remove rear panel: step 5, image 3 of 3

    • Stand the roaster up again and pull away the rear panel from the chassis to expose the remaining components.

    • The mains cable is routed through the panel and it will remain attached, place the panel in a soft bag if you wish to protect the paint throughout the rest of your repairs.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

with 1 other contributor

Kaffelogic

Member since: 07/23/25

2,098 Reputation

18 Guides authored

Badges: 5

+2 more badges

0 Guide Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 6

Past 30 Days: 11

All Time: 47