1. Turn off the camera.
    • Turn off the camera.

      • Locate the power switch on the front of the camera below the camera lens.

      • Slide the switch to the off position.

    Add Comment

  2. Locate the 3 screws that hold the back cover to the camera.
    • Locate the 3 screws that hold the back cover to the camera.

      • One screw is located on the film opener side of the camera.

      • The other screws are located on the opposite side of the camera.

    Add Comment

    • Use the Phillips #00 Precision Screwdriver and remove the screws on the back cover.

    Add Comment

    • Open the film door to remove the back cover.

      • Slide the film door lever to the left until the film door opens.

    Add Comment

    • Use a plastic opening tool to pry the case open until a small gap is present.

      • Repeat this process at the top and bottom of the film door to loosen it.

    Add Comment

    • Grab the top and bottom of the case firmly as shown.

      • Gently remove the back of the camera case with a slight twisting motion.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

David Cottrell

Member since: 10/04/2011

58 Reputation

5 Guides authored

Team

UW Stout, Team 1-2, Zhou Fall 2011 Member of UW Stout, Team 1-2, Zhou Fall 2011

UWSTOUT-ZHOU-F11S1G2

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 4

All Time: 428