Parts

No parts required.

Place the all in one computer face down on a soft, clean surface to avoid scratching the front. Press the tab on the stand cover and lift up. Press the tab on the stand cover and lift up.
  • Place the all in one computer face down on a soft, clean surface to avoid scratching the front.

  • Press the tab on the stand cover and lift up.

Add Comment

Remove the four phillips screws that attach the stand to the computer. Tilt the stand up and out. Tilt the stand up and out.
  • Remove the four phillips screws that attach the stand to the computer.

  • Tilt the stand up and out.

Add Comment

Starting from the optical drive, pry the back cover up with a plastic spudger. The cover is held in place by fragile plastic clips.  Careful to not break them. The cover is held in place by fragile plastic clips.  Careful to not break them.
  • Starting from the optical drive, pry the back cover up with a plastic spudger.

  • The cover is held in place by fragile plastic clips. Careful to not break them.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

18 other people completed this guide.

Tyler

Member since: 06/19/2012

3,800 Reputation

16 Guides authored

Team

TechForce Member of TechForce

Business

2 Members

16 Guides authored

One Comment

I took the back cover off because everytime i connected the power cable the blue light on the power cable would go out and in taking off the back cover i might find something obvious. I did not find anything obvious except for a plastic clip floating around by itself. this may be the cause to a short i am thinking. Any ideas?

kim - Reply

Add Comment

View Statistics:

Past 24 Hours: 10

Past 7 Days: 84

Past 30 Days: 435

All Time: 15,884