Skip to main content

Free Shipping on Domestic Orders $75+

Disassembling Brother PT-D200 Back of Device

Prerequisite Only
This is a prerequisite-only guide! This guide is part of another procedure and isn’t meant to be used alone.

What you need

    1. Disassembling Brother PT-D200 Back of Device, Battery: step 1, image 1 of 1
      • Flip the device over and press down on the indication arrows located at the top center of the back cover and pull it open.

      Ask FixBot

      Add Comment

    2. Disassembling Brother PT-D200 Back of Device: step 2, image 1 of 1
      • Remove the six AAA batteries.

      Ask FixBot

      Add Comment

    1. Disassembling Brother PT-D200 Back of Device, Back of Device: step 3, image 1 of 1
      • Use the Helping Hand 1/4" screwdriver to unscrew the six 3/16" corner screws.

      Ask FixBot

      Add Comment

    2. Disassembling Brother PT-D200 Back of Device: step 4, image 1 of 1
      • Close the back cover and then flip the device over and separate the top half from the bottom half as shown.

      • Be gentle when lifting the top of the device, there is a ribbon cable attaching the two halves together.

      Ask FixBot

      Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

[deleted]

Member since: 01/24/14

301 Reputation

3 Guides authored

0 Guide Comments

Add Comment

View Statistics:

Past 24 Hours: 4

Past 7 Days: 11

Past 30 Days: 21

All Time: 270