Introduction

As a first step to clean, maintain, or install new parts (excluding the blender blades) for the Black and Decker BL3000S the blender base must be taken apart. This guide will provide step by step instructions of how to perform this task.

Image 1/2: Lift the jar straight up from the base without tilting the jar. Image 2/2: Lift the jar straight up from the base without tilting the jar.
  • Before disassembling the blender base, make sure the blender disconnected from any power outlet.

  • Lift the jar straight up from the base without tilting the jar.

Add Comment

Image 1/1:
  • Remove the top three 1/4 inch base screws using a Philip's head screwdriver.

Add Comment

Image 1/2: This provides access to the base screws beneath. Image 2/2: This provides access to the base screws beneath.
  • Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver.

  • This provides access to the base screws beneath.

Add Comment

Image 1/1: One 1/4 Phillips screw
  • Remove the following screws that secure the top and bottom halves of the base.

    • One 1/4 Phillips screw

    • One TA-20 screw

  • Both screwdrivers must have a minimum of a three inch shank (length).

  • Screwdrivers with extenders will not fit down the access holes.

Add Comment

Image 1/1:
  • Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Andrew

Member since: 10/04/2012

170 Reputation

4 Guides authored

Team

Cal Poly, Team 6-34, Regan Fall 2012 Member of Cal Poly, Team 6-34, Regan Fall 2012

CPSU-REGAN-F12S6G34

4 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 8

Past 30 Days: 39

All Time: 2,852