Introduction

How to open it for repairs or battery swap

The lamp opens up at the base: there are two smaller tabs next to the button, the semi-transparent plasic can be pressed in a bit with a knife, put a bit of paper inbetween to prevent the clip from snapping back. Next go with a knife towards one of the large tabs on the side until one side snaps out. Repeat for other side. The lamp opens up at the base: there are two smaller tabs next to the button, the semi-transparent plasic can be pressed in a bit with a knife, put a bit of paper inbetween to prevent the clip from snapping back. Next go with a knife towards one of the large tabs on the side until one side snaps out. Repeat for other side. The lamp opens up at the base: there are two smaller tabs next to the button, the semi-transparent plasic can be pressed in a bit with a knife, put a bit of paper inbetween to prevent the clip from snapping back. Next go with a knife towards one of the large tabs on the side until one side snaps out. Repeat for other side.
  • The lamp opens up at the base: there are two smaller tabs next to the button, the semi-transparent plasic can be pressed in a bit with a knife, put a bit of paper inbetween to prevent the clip from snapping back. Next go with a knife towards one of the large tabs on the side until one side snaps out. Repeat for other side.

Add Comment

Remove the 4 screws (warning: 2x2 different types), out comes the pcb. Detach battery connector at the back. Remove the 4 screws (warning: 2x2 different types), out comes the pcb. Detach battery connector at the back. Remove the 4 screws (warning: 2x2 different types), out comes the pcb. Detach battery connector at the back.
  • Remove the 4 screws (warning: 2x2 different types), out comes the pcb. Detach battery connector at the back.

Add Comment

remove two more screws to get at the battery remove two more screws to get at the battery remove two more screws to get at the battery
  • remove two more screws to get at the battery

Add Comment

Overview of parts
  • Overview of parts

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 other people completed this guide.

petur

Member since: 07/23/2011

178 Reputation

2 Guides authored

3 Comments

I think it is easier to open the lamp by pressing the semi-transparent part at the opposite side of the button.

Matthieu Morel - Reply

How can I open the lamp??? Please post a photo of how are u using the knife because I can't!!!

Alberto Santaella Gallego - Reply

you need to press the clips inward, the picture shows where the clips are. Slide inbetween and press

petur - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 11

All Time: 1,703