Introduction

This is the beginning process to remove or replace any functional component in the AirPort.

Parts

No parts required.

Remove the three 5mm T7 Torx screws from the back panel.
  • Remove the three 5mm T7 Torx screws from the back panel.

Add Comment

Remove one 5mm phillips screw located under the identification sticker.  You will need to remove the sticker or make a hole to get to the screw.
  • Remove one 5mm phillips screw located under the identification sticker. You will need to remove the sticker or make a hole to get to the screw.

Add Comment

Separate the bottom and top casings.
  • Separate the bottom and top casings.

Add Comment

Remove the metal case from the top case of the AirPort, there are no screws holding it on. Remove the four screws from the metal casing.
  • Remove the metal case from the top case of the AirPort, there are no screws holding it on.

  • Remove the four screws from the metal casing.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Michael Garcia

Member since: 10/12/2011

369 Reputation

5 Guides authored

Team

Cal Poly, Team 17-15, Regan Fall 2011 Member of Cal Poly, Team 17-15, Regan Fall 2011

CPSU-REGAN-F11S17G15

3 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 2

Past 30 Days: 25

All Time: 1,467