Introduction

To replace the battery you will need a sharp edged tool, be sure to be careful. The glue on the battery is sticky and hard to get off.

Image 1/1: Before disassembling your device, be sure it is powered off.
  • With a J00 Philips head screwdriver, unscrew the two 4mm black screws located at the bottom of the device.

  • Before disassembling your device, be sure it is powered off.

Add Comment

Image 1/2: Continue prying the edges while moving around the device's perimeter until the back can be easily removed. Image 2/2: Continue prying the edges while moving around the device's perimeter until the back can be easily removed.
  • Using a plastic opening tool, begin softly prying open device by first inserting it in between the front and back panels.

  • Continue prying the edges while moving around the device's perimeter until the back can be easily removed.

Add Comment

Image 1/1: Speaker wires are connected to both the front and back panel.
  • Carefully lift back panel away from the body of the device.

  • Speaker wires are connected to both the front and back panel.

Add Comment

Image 1/2: The soldering tool is hot, and will burn. For how to use a soldering tool follow the [https://www.ifixit.com/Guide/How+To+Solder+and+Desolder+Connections/750|How to Solder Guide] Image 2/2: The soldering tool is hot, and will burn. For how to use a soldering tool follow the [https://www.ifixit.com/Guide/How+To+Solder+and+Desolder+Connections/750|How to Solder Guide]
  • Desolder positive and negative, red and black, wires from the mother board that are connected to the battery.

  • The soldering tool is hot, and will burn. For how to use a soldering tool follow the How to Solder Guide

Add Comment

Image 1/2: Follow the  edge of the battery to loosen the glue. Image 2/2: Follow the  edge of the battery to loosen the glue.
  • Using a metal spudger tool, wedge between battery and metal screen.

  • Follow the edge of the battery to loosen the glue.

Add Comment

Image 1/2: Using your hands, pull up on the battery to pull battery off. Image 2/2: Pulling on the battery causes you to bend the battery. Bending the battery could cause it to break open. Battery fumes are toxic and unsafe.
  • Once the glue is loosened, you should be able to pry off the battery from the screen.

  • Using your hands, pull up on the battery to pull battery off.

  • Pulling on the battery causes you to bend the battery. Bending the battery could cause it to break open. Battery fumes are toxic and unsafe.

  • The battery will be completely disconnected and you can set the battery aside in a safe place.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

One Comment

the replacemet has 3 wires .where go the 3 wire?

javier perez - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 20

Past 30 Days: 89

All Time: 1,952