This translation was generated by a machine and has not been reviewed by a person yet. Speak this language? Review it.
Device Disassembly
Hoi-Soo Ryoo and
Last updated on Nov 11, 2026
Views: 199
View statistics:
- Past 24 Hours:
- 8
- Past 7 Days:
- 48
- Past 30 Days:
- 197
- All Time:
- 199
Comments: 0
No one has left comments on this guide. Will you be first?
Go to guide commentsCompleted: 0 1
No one has marked this guide "completed." Will you be the first?
1 person has marked this guide "completed." It's you — great job!
Favorites: 0 1
No one has favorited (and subscribed to) this guide. Will you be the first?
1 person has favorited (and subscribed to) this guide — and that's you!
Community-Contributed Guide
An awesome member of our community made this guide. It was not created by iFixit staff.
Introduction
Go to step 1 ↓This guide shows how to disassemble the body and lens assembly.
-
-
-
Setting the mode switch to ST reveals one hidden screw.
-
Remove the three long screws and two small screws as shown in the picture.
Ask FixBot
-
-
-
Grip the bottom of the sliding cover and pry it forward to remove it. Be careful not to lose the roller located at the top.
-
-
-
-
Remove the one screw on the upper right and the one screw on the spool side of the film chamber,
-
then perform removal.
-
-
-
Remove the red switch cover. Be careful not to damage the cover.
-
Remove the screws of the rewinder to remove the rewinder.
-
Then, remove the two screws under the rewinder.
-
-
To perform reassembly of the device, follow these instructions in reverse order.
