Introduction

By following the steps in this guide one should be able to replace the complete display assembly on the a Dell Inspiron 7568.

Parts

No parts required.

  1. Remove the ten 7mm Phillips #1 screws on the bottom cover.
    • Remove the ten 7mm Phillips #1 screws on the bottom cover.

    • Remove the bottom cover.

  2. Remove the four 3mm Phillips #1 screws holding the battery.
    • Remove the four 3mm Phillips #1 screws holding the battery.

    • Unhinge the connector cable to the battery.

    • Remove the battery.

    • Unscrew & remove the two 3mm screws (using a ph1 screwdriver bit) and the cable bracket, above the motherboard

    • Doing this will allow one to access the LCD-motherboard connector cables.

    • Unscrew the 7mm screws that secure the left and right hinges (using a ph1 screwdriver bit).

    • Disconnect the antenna cable (under the left hinge)

    • Disconnect the LCD and Touchscreen display cables under the right hinge.

    • These are a set of two cables. For better image see image two in step one of this guide.

    • Carefully separate the screen from the bottom half of the device.

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Yash Samant

Member since: 02/22/2017

352 Reputation

3 Guides authored

Team

USF Tampa, Team S2-G2, Lacy Spring 2017 Member of USF Tampa, Team S2-G2, Lacy Spring 2017

USFT-LACY-S17S2G2

4 Members

7 Guides authored

0 Comments

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 12

All Time: 599