Introduction

This guide will demonstrate how to separate the Clam Shell from the DeWalt DW938.

Parts

No parts required.

Image 1/3: Use a torque bit screw driver to remove 6 T10 21.5 mm screws on the handle. Image 2/3: Insure power source is removed from tool. Image 3/3: Insure blade is removed from tool.
  • Use a torque bit screw driver to remove the T10 18.3 mm screw on the handle.

  • Use a torque bit screw driver to remove 6 T10 21.5 mm screws on the handle.

  • Insure power source is removed from tool.

  • Insure blade is removed from tool.

Add Comment

Image 1/1:
  • Carefully cut the safety sticker with a blade along the seam.

Add Comment

Image 1/1:
  • Remove the Clam Shell from the handle unit.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Christopher Chin

Member since: 03/08/2017

304 Reputation

3 Guides authored

Team

IUPUI, Team S4-G4, Baechle Spring 2017 Member of IUPUI, Team S4-G4, Baechle Spring 2017

IUPUI-BAECHLE-S17S4G4

4 Members

3 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 4

All Time: 51