Introduction

This guide will show you how to replace the black air filter cap located on the top of the motor.

Parts

No parts required.

Using a T-20 hex head screw, unscrew the two screws located at the top and bottom of the black air filter. The screws are directly above and below the yellow  lettering.
  • Using a T-20 hex head screw, unscrew the two screws located at the top and bottom of the black air filter. The screws are directly above and below the yellow lettering.

Add Comment

Use your hands to pull the black air filter away from the body of the saw to detach.
  • Use your hands to pull the black air filter away from the body of the saw to detach.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Scott Weinhardt

Member since: 01/25/2017

501 Reputation

5 Guides authored

Team

Cal Poly, Team 8-2, Banghart Winter 2017 Member of Cal Poly, Team 8-2, Banghart Winter 2017

CPSU-BANGHART-W17S8G2

3 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 2

Past 30 Days: 4

All Time: 54