Introduction

The DeWalt DW660 has an amazing dynamic power switch that makes operating the device extremely easy. The bump off feature of the switch allows for an easy shut off with minimal effort.

Parts

No parts required.

Remove the four 19mm T20 Torx screws at the rear of the device.
  • Remove the four 19mm T20 Torx screws at the rear of the device.

Add Comment

Black Friday
Broken doesn't stand a chance.
Remove the cover to expose the inside of the tool.
  • Remove the cover to expose the inside of the tool.

Add Comment

Pick up the switch from the device with the wires still attached. Remove the actuator from the switch. Pull the two wires from the switch.
  • Pick up the switch from the device with the wires still attached.

  • Remove the actuator from the switch.

  • Pull the two wires from the switch.

  • Make sure to remember where each pin went on the switch after replacement.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Joseph Pacitto

Member since: 03/23/2016

231 Reputation

2 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 7

All Time: 124