Introduction

The power cord can simply be replaced by opening the back of the device and unscrewing the casing. Make sure that the device is not plugged in before working on it.

Parts

No parts required.

  1. Using a T20 Torx Screwdriver, unscrew the four 19mm screws from the back casing.
    • Using a T20 Torx Screwdriver, unscrew the four 19mm screws from the back casing.

    • After unscrewing, remove the back casing from the device.

    Add Comment

  2. Disconnect the wires from the switch terminals.
    • Disconnect the wires from the switch terminals.

    Add Comment

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove the ground wire from the motor by pulling it gently.

    Add Comment

    • Using the T20 Torx screwdriver, unscrew two screws from the bracket that holds the power cord in the casting.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

AL25

Member since: 03/09/2016

222 Reputation

2 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 8

All Time: 110