Introduction
If you realize your battery charger for your drill is not charging, there may be a blown fuse which can be replaced by following this guide.
What you need
-
-
Remove the four 13 mm, Torx Security #15 screws found on the bottom of the charger.
-
-
-
-
Remove the 19 mm, Torx Security #10 screw found in the charger port.
-
Then pull the top of the charger off separating it from the bottom.
-
-
-
Once you have located the fuse, if you have the replacement fuse just pull the old one out and put the new one in.
-