Introduction

If the battery of your drill is not giving the drill power, a problem you could have is deteriorated battery cells. This guide will show you how to replace the battery cells.

Image 1/1:
  • Compress the buttons on either side of the battery and lift the drill away from battery.

Add Comment

Image 1/1:
  • Remove battery from drill.

Add Comment

Image 1/2: Image 2/2:
  • Remove the six 19 mm, Torx Security 15 screws from the top of the battery.

Add Comment

Image 1/1:
  • Pull off the battery cover, exposing the battery cells.

Add Comment

Image 1/3: If the battery cells seem like they will not come out, you may need to pull harder cautiously. Recycle the old battery cells. Image 2/3: If the battery cells seem like they will not come out, you may need to pull harder cautiously. Recycle the old battery cells. Image 3/3: If the battery cells seem like they will not come out, you may need to pull harder cautiously. Recycle the old battery cells.
  • Remove the old battery cells by slowly pulling them out of the top piece of the battery.

    • If the battery cells seem like they will not come out, you may need to pull harder cautiously. Recycle the old battery cells.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jonathan Hamel

Member since: 03/10/2016

413 Reputation

4 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 6

Past 7 Days: 10

Past 30 Days: 28

All Time: 330