Introduction
Disassembling the Mavic Mini drone to replace any of the defective parts.
After replacing the motherboard or gimbal camera, you need to calibrate the drone. How to calibrate the DJI Mavic Mini, watch this manual https://youtu.be/mu03HWXplM4
Video Instructions
Almost done!
To reassemble your device, follow these instructions in reverse order.
Conclusion
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
One Comment
Hey, wanted to say thanks for this video. Super helpful. I crashed the eff out of my Mavic Mini and was getting an error 30045, "Gyroscope initialization failed. Restart aircraft." Looks like my ribbon cable that connects the gyroscope chip module to the main board somehow got ripped (or possibly melted through, I was flying in a rather warm climate.) Of course, it's the longest and most complex cable in the drone, so it'll be a job to get it replaced. I'm ordering a new one and going to see if I can switch it out successfully. Thank you!!
Chris Zirker - Reply