Introduction
Oops... I forgot to put the "loosening" washer on my Sterwins trimmer!
How do I do it?
What you need
-
-
-
You can now disconnect the lower tube from the cutting head.
-
-
-
Clamp the axle in a vise.
-
Rotate the head so that the head and cutting assembly can be disassembled.
-
-
-
Now that you've saved your device, don't forget to put the washer back on!
-
Tighten the two Torx T30 screws to secure the bottom section and the tube.
-
Finally, add the "loosening" washer to avoid anything getting stuck again.
Finally, add the "loosening" washer to avoid anything getting stuck again.
Cancel: I did not complete this guide.
2 other people completed this guide.
Special thanks to these translators:
100%
shingle is helping us fix the world! Want to contribute?
Start translating ›