Introduction
This guide will allow you to get to the most basic components of the device where you will be able to perform many necessary replacements.
What you need
-
-
-
Remove the two 6 mm Phillips #2 screws that secure the knob circuit board.
-
Move the circuit board to the side so it is out of the way.
Ask FixBot
-
-
-
-
Remove the two 6 mm Phillips #2 screws that secure the white plastic LED holder.
-
-
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
Cal Poly, Team 1-12, Maness Spring 2016 Member of Cal Poly, Team 1-12, Maness Spring 2016
CPSU-MANESS-S16S1G12
4 Members
72 Guides authored
