Skip to main content

You're viewing a previously published version of this guide.  View latest version

Older Newer

Introduction

Replace your dying battery to restore the power of your CrystalView Netbook.

  1. Power off the device before beginning disassembly.
    • Power off the device before beginning disassembly.

    • Using a Phillips #00 Screwdriver, take out the following screws:

    • Two 6 mm screws

    • Three 4 mm screws

    • Four 3 mm screws

    • These screws can be taken out in any order.

  2. Using a Phillips #00 Screwdriver, remove the screws located under the top two standoffs.
    • Using a Phillips #00 Screwdriver, remove the screws located under the top two standoffs.

  3. Remove the cover off the back of the device.
    • Remove the cover off the back of the device.

  4. Remove the battery using a plastic spudger.
    • Remove the battery using a plastic spudger.

    • Do not use a metal spudger, as this can damage the device.

  5. Peel back the yellow film on the old  battery to expose the red and black wires De-solder these wires to disconnect the old battery
    • Peel back the yellow film on the old battery to expose the red and black wires

    • De-solder these wires to disconnect the old battery

    • Be careful while using a soldering iron as it is extremely hot.

    • Follow the How To Solder and Desolder Connections guide for help.

Courtney Clark

Member since: 01/12/2017

212 Reputation

2 Guides authored

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 179