Conair Instant Heat Curling Wand CD778CS Power Cord Replacement

Introduction

This guide will walk the user through replacing the power cord in their Conair Curling Wand. The most common problem this device encounters is power cord failure which does not enable the wand to heat up. This guide is moderately easy and the most difficult part is opening up the device.

What you need

Step 1 Power Cord

Conair Instant Heat Curling Wand CD778CS Power Cord Replacement, Power Cord: step 1, image 1 of 1

Remove 2 mm screw with a Phillips #0 screwdriver.
Make sure curling wand is unplugged and cooled before beginning.

Edit

Step 2

Remove the next 4 mm screw with a Phillips #0 screwdriver.

Edit

Step 3

Use a flat head screwdriver to assist in prying open the plastic housing.

Edit

Step 4

Gently open the plastic housing making sure to evenly pull apart the plastic so it does not bend or snap.

Edit

Step 5

Remove the plastic ring on the bottom of the curling iron by wiggling back and forth and pulling down.
Use your flat head screwdriver for assistance if the plastic housing is firmly in place and does not move.

Edit