Introduction

If your hair dryer's fan grill is damaged or dirty, this guide will show you how to replace it.

Parts

No parts required.

Image 1/1: Hold the hair dryer by the handle so that  the back panel faces up.
  • Caution: Unplug the hair dryer before attempting this guide. Leaving the device plugged in may result in electrocution and damage to the device.

  • Hold the hair dryer by the handle so that the back panel faces up.

Add Comment

Image 1/2: Image 2/2:
  • Remove the two 15.875 mm Phillips #2 screws from the back panel.

Add Comment

Image 1/3: Continue separating the back panel, working along the seam. Image 2/3: With moderate force, completely remove the back panel from the hair dryer. Image 3/3: With moderate force, completely remove the back panel from the hair dryer.
  • Starting from where the cord attaches to the handle, pull apart the two plastic panels.

  • Continue separating the back panel, working along the seam.

  • With moderate force, completely remove the back panel from the hair dryer.

Add Comment

Image 1/2: Remove the two 1-inch Phillips #2 screws from the back of the fan motor. Image 2/2: Remove the two 1-inch Phillips #2 screws from the back of the fan motor.
  • Hold the hair dryer by the nozzle so that the handle points to the left.

  • Remove the two 1-inch Phillips #2 screws from the back of the fan motor.

Add Comment

Image 1/3: Pull on the back of the fan motor to gently lift the motor out of the hair dryer. Image 2/3: Lift the attached electrical wiring and heat shield completely out of the hair dryer. Image 3/3: Lift the attached electrical wiring and heat shield completely out of the hair dryer.
  • Caution: If you recently used the hair dryer, wait at least 10 minutes before attempting this step. The heating element may still be very hot and can cause serious burns.

  • Pull on the back of the fan motor to gently lift the motor out of the hair dryer.

  • Lift the attached electrical wiring and heat shield completely out of the hair dryer.

Add Comment

Image 1/1:
  • Hold the front panel of the hair dryer by the nozzle facing upward.

Add Comment

Image 1/2: Image 2/2:
  • Using your index finger push the fan grill down with moderate force.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Timothy Lo

Member since: 04/22/2014

836 Reputation

7 Guides authored

Team

Cal Poly, Team 10-58, Amido Spring 2014 Member of Cal Poly, Team 10-58, Amido Spring 2014

CPSU-AMIDO-S14S10G58

4 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 6

All Time: 385