Introduction

To complete this guide, you will need to disassemble your device and use a soldering iron to replace the battery.

Make sure to power off the device before you begin to take apart your device. Not doing so could potentially cause harm.

Parts

No parts required.

Use the plastic opening tool help push out the microSD card from the microSD slot. Use the plastic opening tool help push out the microSD card from the microSD slot.
  • Use the plastic opening tool help push out the microSD card from the microSD slot.

Add Comment

Use the plastic opening tool to unclip the plastic front from the plastic back. Use the MicroSD slot to initially start the unclipping.
  • Use the plastic opening tool to unclip the plastic front from the plastic back. Use the MicroSD slot to initially start the unclipping.

Add Comment

The battery is glued onto the black plastic. Use the plastic opening tool to pry the battery from the black plastic. The battery is glued onto the black plastic. Use the plastic opening tool to pry the battery from the black plastic.
  • The battery is glued onto the black plastic. Use the plastic opening tool to pry the battery from the black plastic.

Add Comment

Unsolder the red and black wires that are connected to the battery from the logic board using a soldering iron. Tips on how to solder can be found here.
  • Unsolder the red and black wires that are connected to the battery from the logic board using a soldering iron.

  • Tips on how to solder can be found here.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Katherine

Member since: 01/22/2015

385 Reputation

3 Guides authored

Team

UWT Liner: Group 2 Member of UWT Liner: Group 2

Community

4 Members

3 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 95