Installing Compaq Evo N1000v Palm Rest

Step 1 LED Cover

• Flip the laptop over with the rear panel facing forward.
Step 2

• Using a TR8 Torx screwdriver, remove the two T8 Torx screws that secure the LED cover to the base enclosure.
Step 3
• Flip the laptop back over with the front facing forward. Open the screen.
Step 4
• Locate the F1 and F2 keys near the top left corner of the keyboard.
Step 5
• While holding the F1 and F2 keys, insert a spudger between the keys into the notch in the LED cover. Lift up.
Step 6
• Locate the Scroll and Pause keys near the top right corner of the keyboard.
Step 7
• While holding the Scroll and Pause keys, insert a spudger between the keys into the notch in the LED cover. Lift up.
Step 8
• Insert a spudger between the F7 and F8 keys. Lift up to remove the LED cover.
Step 9 Keyboard
• Lift the back edge of the keyboard and pull towards the screen.
Step 10
• Pull the cable and lift up to release.
Step 11
• Remove the keyboard.
Step 12 Palm Rest
• Flip the computer bottom side up with the rear facing forward.
Step 13
• Remove the six screws shown in picture.
Step 14
• Flip the computer top side up with the front facing you.
Step 15
• Lift up the palm rest from the front edge and swing it towards the screen.
Step 16
• Locate the first connector. Disconnect by firmly pulling up.
Step 17
• Locate the second connector. Remove by firmly pulling up.
Step 18
• Remove the palm rest.

Author

with 10 other contributors

Alex Hernandez

Member since: 04/14/10

46 Reputation

4 Guides authored

Badges: 9

• 
• 
• 

+6 more badges

Team

Cal Poly, Team 29-74, Johann Spring 2010 Member of Cal Poly, Team 29-74, Johann Spring 2010

CPSU-JOHANN-S10S29G74

3 Members

14 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview