Use a spudger to remove the four rubber screw covers from the four back corners of the tablet.
  • Use a spudger to remove the four rubber screw covers from the four back corners of the tablet.

Add Comment

Place the PH00 screwdriver and use it to remove the four 0.5 cm screws from each corner of the tablet.
  • Place the PH00 screwdriver and use it to remove the four 0.5 cm screws from each corner of the tablet.

Add Comment

Place a metal spudger tool in between the front and back panels of the tablet and begin to pry the base from the front panel by moving the metal tool around the perimeter of the tablet.
  • Place a metal spudger tool in between the front and back panels of the tablet and begin to pry the base from the front panel by moving the metal tool around the perimeter of the tablet.

  • Note that clicking noises will be heard during this process, the panels are assembled well so it may take some force to separate the two panels.

  • Use caution while prying, do not stick the metal spudger in too far as it may damage internal components

Add Comment

Remove the two ribbon cables attached to the logic board.
  • Remove the two ribbon cables attached to the logic board.

Add Comment

Remove the tape covering the ribbon cables and remove the camera module.
  • Remove the tape covering the ribbon cables and remove the camera module.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Jake

Member since: 03/11/2015

158 Reputation

1 Guide authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 90