Press the eject button to view the laser inside. Using the blue plastic tool and the tweezers, remove the ribbon cable. Using the blue plastic tool and the tweezers, remove the ribbon cable.
  • Press the eject button to view the laser inside.

  • Using the blue plastic tool and the tweezers, remove the ribbon cable.

Add Comment

Remove the six 1cm screws on the bottom of the device with the Phillips #1 screwdriver. Do not lift the top of the DVD player too quickly because there are wires attached on the inside. Pry the top of the device open from the right side where the buttons are located.
  • Remove the six 1cm screws on the bottom of the device with the Phillips #1 screwdriver.

  • Do not lift the top of the DVD player too quickly because there are wires attached on the inside.

  • Pry the top of the device open from the right side where the buttons are located.

Add Comment

Black Friday
Broken doesn't stand a chance.
When pulling the ribbon cables out, make sure not to pull by the wires, as this can cause damage to them. Pinch the plastic adapter with two fingers to remove the wires circled in red from the circuit board. Pinch the plastic adapter with two fingers to remove the wires circled in red from the circuit board.
  • When pulling the ribbon cables out, make sure not to pull by the wires, as this can cause damage to them.

  • Pinch the plastic adapter with two fingers to remove the wires circled in red from the circuit board.

Add Comment

Take the top portion of the DVD player and orient the device as shown in the first picture. Remove the four 0.2" screws circled in red.
  • Take the top portion of the DVD player and orient the device as shown in the first picture.

  • Remove the four 0.2" screws circled in red.

Add Comment

Losen the screw circled in red. The screw will not come out of the plastic knob. Turn the plastic knob 90 degrees to the right so that the cable comes out freely.
  • Losen the screw circled in red.

  • The screw will not come out of the plastic knob.

  • Turn the plastic knob 90 degrees to the right so that the cable comes out freely.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Yufay Chow

Member since: 01/23/2012

68 Reputation

4 Guides authored

Team

Cal Poly, Team 10-36, Amido Winter 2012 Member of Cal Poly, Team 10-36, Amido Winter 2012

CPSU-AMIDO-W12S10G36

4 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 311