Skip to main content

Introduction

Disassembly guide for Cisco Aironet 1242ag Access Point

Tools

Parts

No parts specified.

  1. The equipment cover is held by 4 screws. The equipment cover is held by 4 screws.
    • The equipment cover is held by 4 screws.

  2. Once the 4 screws are removed, push to the side to remove the cover.
    • Once the 4 screws are removed, push to the side to remove the cover.

  3. The card is attached to the bottom plate by 4 screws Before removing the logic board, disconnect the antenna cables in both parts of the device. There is a total of 4 cables. Use a tweezer or a spudger to disconnect them.
    • The card is attached to the bottom plate by 4 screws

    • Before removing the logic board, disconnect the antenna cables in both parts of the device.

    • There is a total of 4 cables. Use a tweezer or a spudger to disconnect them.

  4. Write the wisdom here. Write the wisdom here. Write the wisdom here.
    • Write the wisdom here.

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Special thanks to these translators:

es en

91%

These translators are helping us fix the world! Want to contribute?
Start translating ›

Attached Documents

Eneider Colina

Member since: 09/20/2013

2,297 Reputation

9 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 5

Past 30 Days: 18

All Time: 636