Image 1/1:
  • Using a Phillips #00 screwdriver, remove the four 1.1mm long screws from the top side.

Add Comment

Image 1/1: Remove the warranty sticker across the bottom.
  • Using a Phillips #00 screwdriver, remove the four 1.1mm long screws from the bottom side.

  • Remove the warranty sticker across the bottom.

Add Comment

Image 1/2: The outer shell should easily come apart. Image 2/2: The outer shell should easily come apart.
  • Gently lift off the back and front casing.

  • The outer shell should easily come apart.

Add Comment

Image 1/1:
  • Make sure the device screen is face down.

Add Comment

Image 1/3: Raise the bottom edge of the hard drive 15 degrees up from the device. Image 2/3: Raise the bottom edge of the hard drive 15 degrees up from the device. Image 3/3: Raise the bottom edge of the hard drive 15 degrees up from the device.
  • Using the plastic opening tool, wedge the tool underneath the bottom left edge of the hard drive.

  • Raise the bottom edge of the hard drive 15 degrees up from the device.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • Place fingers on the IDE connectors and gently slide the hard drive out from the IDE module.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Ryan Sutardji

Member since: 06/29/2012

171 Reputation

7 Guides authored

Team

Cal Poly, Team 1-4, Regan SU 2012 Member of Cal Poly, Team 1-4, Regan SU 2012

CPSU-REGAN-SU12S1G4

4 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 789