Introduction

Using a PH100 screwdriver, a set of wire cutters, and a soldering tool, the on/off switch can be replaced in the Casdon Dyson Ball.

Remove one 9.2mm (0.36 in) screw using the PH00 screwdriver.
  • Remove one 9.2mm (0.36 in) screw using the PH00 screwdriver.

  • Remove the battery cover by pulling it away from the vacuum once the 9.2mm (0.36 in) screw is removed.

Add Comment

Remove batteries from the vacuum by pulling them out and away from the vacuum.
  • Remove batteries from the vacuum by pulling them out and away from the vacuum.

Add Comment

  • Remove four 9.2mm (0.32 in) screws from the back of the vacuum using the PH00 screwdriver.

Add Comment

  • Remove the cover to the on/off switch by pulling up on the cover from the front of the vacuum.

Add Comment

  • Cut the two wires connected to the on/off switch using a set of wire cutters.

Add Comment

  • Remove the two 9.2mm (0.32 in) screws which hold the on/off switch to the vacuum using the PH00 screwdriver.

Add Comment

  • Remove the on/off switch by pulling it away from the vacuum with your fingers.

  • Replace the faulty on/off switch with the new on/off switch.

  • Solder the new on/off switch's wires to the vacuum's wires using a soldering station.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Seldon Price

Member since: 11/07/2017

531 Reputation

5 Guides authored

Team

IUPUI, Team S3-G5, Harley Fall 2017 Member of IUPUI, Team S3-G5, Harley Fall 2017

IUPUI-HARLEY-F17S3G5

3 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 11

All Time: 101