Introduction

The panels of the Canon ZR70MC hold the camcorder together. The side panel in particular protects the main circuit board of the camcorder and also protects the imaging films located inside. This guide will show you how to take off the side panel, allowing easier access to the LED screen and lens component of the Canon ZR70MC. You should also have a designated location for the small parts of the camcorder so that you do not lose any pieces. Also, do not damage any wires that you come across.

Parts

No parts required.

Unscrew the  3.35mm screw.
  • Unscrew the 3.35mm screw.

Add Comment

Turn the ZR70MC so that you can see the bottom of the camcorder.
  • Turn the ZR70MC so that you can see the bottom of the camcorder.

  • Unscrew the 3.35 mm located in the top left portion of the camera.

Add Comment

  • Turn the camera on the side and remove the cover for the audio inputs. There is a 2.65 mm screw located behind the cover.

  • Remove the 2.65 mm screw.

Add Comment

  • Remove the cover located on the front of the camcorder and remove the cover by pulling on the bottom groove.

  • Locate and remove the two 3.35 mm screws.

Add Comment

  • Turn the camcorder so that the bottom is facing up and open the tape cassette compartment.

  • There is one 3.35 mm screw located under the tape cassette panel on the front left side of the camcorder. Remove the screw.

Add Comment

  • Now that all of the screws are removed, remove the front panel by gently pulling on the front panel.

  • The speaker will be connected to the main body by a wire. Be careful not to damage this wire.

Add Comment

  • Use tweezers to gently pull the speaker wire from the main body of the camcorder.

  • Pull the front panel completely away from the main body of the camcorder.

Add Comment

  • Remove all 3.75 mm screws from the bottom of the camcorder.

Add Comment

  • Turn the camcorder so that the back is facing you.

  • Remove the 3.75 mm screws from the back of the camcorder that hold the side panel in place.

Add Comment

  • Now that all of the screws are removed, gently pull off the side panel of the camcorder.

Add Comment

  • Gently pull the two black wires from their connections. These black wires are the only thing left connecting the side panel to the main body of the camcorder.

Add Comment

  • Gently pull the orange films out of their connections. This will allow you access to all components of the main body.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

khalid clarke

Member since: 09/26/2017

701 Reputation

7 Guides authored

Team

USF Tampa, Team S13-G2, Boczar Fall 2017 Member of USF Tampa, Team S13-G2, Boczar Fall 2017

USFT-BOCZAR-F17S13G2

3 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 2

Past 30 Days: 2

All Time: 42