Canon Powershot S200 Motherboard Replacement

Step 1 Battery



• Slide the grey latch to open the battery compartment.
Step 2



• Push and slide the orange retaining clip to the right to remove the battery.
Step 3
• Remove battery from the camera.
Step 4 Motherboard
• Remove the lanyard.
Step 5
• Remove the two 2.3mm screws (underneath the name plate) and two 2.8mm screws (next to the threaded tripod mount) from the bottom face of the camera.
• Be careful to keep track of the different screw sizes as you proceed with this guide.
Step 6
• Remove the single 3.8mm screw from the back face of the camera.
Step 7
• Remove the two 2.3mm screws from the right face of the camera.
Step 8
• Remove the two 3.2mm screws (outside edge) and two 3.7mm screws (towards middle) from the left side of the camera body.
Step 9
• Pull the back face panel away from the front end of the body. This may take some wiggling and force.
Step 10
• Remove the CF card door from the left side of the camera body.
Step 11
• Remove the rubber digital a/v out cap by sliding it out of the groove on the front plate.
Step 12
• Remove the front face by sliding it off.
Step 13
• Remove the rubber seal that goes over the right side of the viewfinder.
Step 14
• Remove the two 3.9mm screws that retain the laminated cooper sheet.
Step 15
• Remove the seven wire connections that connect to the motherboard.
Step 16
• Remove the single 3.8mm screw that is on the motherboard.
Step 17
• Carefully remove the motherboard from the main frame of the camera body.

Author

with 10 other contributors

Orlando Zuniga

Member since: 04/14/11

11 Reputation

1 Guide authored

Badges: 3

• 
• 
• 

Team

Cal Poly, Team 20-70, Walters Spring 2011 Member of Cal Poly, Team 20-70, Walters Spring 2011

CPSU-WALTERS-S11S20G70

5 Members

4 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview