Parts

No parts required.

Remove the two 3.1mm screws from the bottom of the camera.
  • Remove the two 3.1mm screws from the bottom of the camera.

  • The display screen of the camera should be facing towards you.

Add Comment

With the screen facing you, rotate the camera counter clock-wise onto it's side.
  • With the screen facing you, rotate the camera counter clock-wise onto it's side.

  • Remove the two 3.1mm screws.

Add Comment

With the screen still facing you, rotate the camera 180 degrees.
  • With the screen still facing you, rotate the camera 180 degrees.

  • The side with the charging port should now be facing up.

Add Comment

Use the tool (or fingers) to pry open the charging port cover. Rotate the cover so that you have access to the screw underneath.
  • Use the tool (or fingers) to pry open the charging port cover.

  • Rotate the cover so that you have access to the screw underneath.

  • Remove both 3.1mm screws.

  • The image still shows the screw from step 3 in place.

Add Comment

Turn the camera so the bottom is once again facing up. With the battery door still open, use a spudger to remove the cover from the front of the camera.
  • Turn the camera so the bottom is once again facing up.

  • With the battery door still open, use a spudger to remove the cover from the front of the camera.

Add Comment

Pull off the the front cover.
  • Pull off the the front cover.

  • Be careful not to break the tabs that hold it in place.

Add Comment

Use the spudger to remove the back cover. Be careful not to break the tabs. Be careful not to break the tabs.
  • Use the spudger to remove the back cover.

  • Be careful not to break the tabs.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Jacob

Member since: 03/17/2015

454 Reputation

3 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 6

Past 30 Days: 14

All Time: 634