Introduction

This guide teaches you how to replace your broken or worn Canon PowerShot SX280 HS LCD screen. It will show you how to remove and install a new screen. The process is safe and easy. It requires no special skills.

  1. Turn off the camera and remove the battery.
    • Turn off the camera and remove the battery.

  2. Use a Phillips #00 screwdriver to remove the two 3.4 mm screws on the left side of the camera.
    • Use a Phillips #00 screwdriver to remove the two 3.4 mm screws on the left side of the camera.

  3. Using the same screwdriver, remove the two 3.4 mm screws on the bottom of the camera.
    • Using the same screwdriver, remove the two 3.4 mm screws on the bottom of the camera.

  4. Lift the small plastic tab, located on the front of the camera, to remove the GPS cover.
    • Lift the small plastic tab, located on the front of the camera, to remove the GPS cover.

  5. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    Browse Our Store
  6. Using the same Phillips screwdriver, remove the two screws that hold the LCD screen.
    • Using the same Phillips screwdriver, remove the two screws that hold the LCD screen.

    • Remove the other small tab attached to the LCD screen.

  7. When removing the plastic casting, do not pull it all the way off. Detach the small tab first and make sure nothing else is attached to the casing.
    • When removing the plastic casting, do not pull it all the way off. Detach the small tab first and make sure nothing else is attached to the casing.

  8. To remove the tabs from the camera, remove all screws.
    • To remove the tabs from the camera, remove all screws.

    • Slowly lift the screen out of the camera using the tabs.

  9. Use the tabs, outlined in red, to slowly remove the LCD screen.
    • Use the tabs, outlined in red, to slowly remove the LCD screen.

    • Remove the screws to remove the camera motherboard.

  10. Insert the replacement LCD screen.
    • Insert the replacement LCD screen.

    • Ensure that the long strip is attached to the original position.

  11. To reassemble your device, follow Steps 2 to 9 in reverse order.
    • To reassemble your device, follow Steps 2 to 9 in reverse order.

Finish Line

One other person completed this guide.

Osmand A Munoz

Member since: 03/23/2015

228 Reputation

2 Guides authored

Team

0 Comments

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 11

All Time: 1,513