Introduction

This guide will show you how to properly replace the screen on your CanonPowershot SD1300 IS.

Parts

No parts required.

Remove the two 2mm J00 screws on the right exterior. Remove a single 4 mm J00 on the bottom exterior. Remove a single 3mm J00 on the left exterior.
  • Remove the two 2mm J00 screws on the right exterior.

  • Remove a single 4 mm J00 on the bottom exterior.

  • Remove a single 3mm J00 on the left exterior.

Once the front shell of the camera is removed the back shell should slide off just the same.
  • Once the front shell of the camera is removed the back shell should slide off just the same.

New Battery = Faster iPhone
Fix Kits starting at $16.99
Use one of your plastic opening tools to separate the screen from the main body of your PowerShot.
  • Use one of your plastic opening tools to separate the screen from the main body of your PowerShot.

Hold screen and remove connecting power cord by pulling cord away from the faulty screen.
  • Hold screen and remove connecting power cord by pulling cord away from the faulty screen.

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Clayton

Member since: 03/20/2017

501 Reputation

5 Guides authored

Team

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 1

Past 30 Days: 9

All Time: 63