Introduction

This guide will show you how to properly replace your Flash Assembly on your Canon PowerShot SD1300 IS.

Parts

No parts required.

Remove the two 2mm J00 screws on the right exterior. Remove a single 4 mm J00 on the bottom exterior. Remove a single 3mm J00 on the left exterior.
  • Remove the two 2mm J00 screws on the right exterior.

  • Remove a single 4 mm J00 on the bottom exterior.

  • Remove a single 3mm J00 on the left exterior.

Add Comment

Once the front shell of the camera is removed the back shell should slide off just the same.
  • Once the front shell of the camera is removed the back shell should slide off just the same.

Add Comment

Remove a 3mm J00 screw from behind wires under the flash.
  • Remove a 3mm J00 screw from behind wires under the flash.

Add Comment

Use plastic opening tool to remove the screen to gain access to the screws to remove the Flash Assembly.
  • Use plastic opening tool to remove the screen to gain access to the screws to remove the Flash Assembly.

Add Comment

Remove the two 3mm J00 screws under the screen.
  • Remove the two 3mm J00 screws under the screen.

  • Remove the 4mm J00 screws under the screen.

  • The flash assembly is now released and should be able to be removed from the front side of the camera.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Clayton

Member since: 03/20/2017

501 Reputation

5 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 1

Past 30 Days: 4

All Time: 46