Skip to main content

You're viewing a previously published version of this guide.  View latest version

Older Newer

Introduction

Use this guide to replace the front and back covers of the Canon PowerShot SD1200 IS camera or to access damaged internal components.

Parts

No parts specified.

  1. Remove the battery.
    • Remove the battery.

  2. Remove the two screws from the side  of the camera casing with the strap.  (4mm Phillips 00) Remove the two screws from the bottom of the camera. (4mm Phillips 00) Remove the two screws from the right side of the camera opposite the strap. (2mm Phillips 00)
    • Remove the two screws from the side of the camera casing with the strap. (4mm Phillips 00)

    • Remove the two screws from the bottom of the camera. (4mm Phillips 00)

    • Remove the two screws from the right side of the camera opposite the strap. (2mm Phillips 00)

  3. Pull off the front cover. If the top of the cover sticks, use gentle downward pressure on the retention clips above the lens to release.
    • Pull off the front cover.

    • If the top of the cover sticks, use gentle downward pressure on the retention clips above the lens to release.

    • Remove the back cover.

Jeff Casper

Member since: 09/15/2016

811 Reputation

7 Guides authored

Team

USF Tampa, Team 17-5, Blackwell Fall 2016 Member of USF Tampa, Team 17-5, Blackwell Fall 2016

USFT-BLACKWELL-F16S17G5

3 Members

7 Guides authored

View Statistics:

Past 24 Hours: 1

Past 7 Days: 2

Past 30 Days: 7

All Time: 306