Introduction

We will be teaching how to replace the screen on a Canon PowerShot S230.

Image 1/1:
  • Unscrewing the small screws to take off the backing, screws are on the side and there are 4

Add Comment

Image 1/3: Look for all screws before moving on Image 2/3: Look for all screws before moving on Image 3/3: Look for all screws before moving on
  • Pry open the backing

  • Look for all screws before moving on

Add Comment

Image 1/1: It's fine if you just use your hands
  • Remove metal shield from camera

  • It's fine if you just use your hands

Add Comment

Image 1/1: REMOVE ALL SCREWS BEFORE MOVING ON
  • Pry off the the front casing

  • REMOVE ALL SCREWS BEFORE MOVING ON

Add Comment

Image 1/2: Image 2/2:
  • Remove screws and metal shield at the bottom of the camera

Add Comment

Image 1/1:
  • Remove the screen, also remove any screws that may get in the way, if the screen pops out it’s okay, it’s suppose to do that. Remove the screw at the bottom

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • Remove the highlighted screws to remove the copper facing

Add Comment

  • Now that the screen is replaced, all you need to do is go through the steps in reverse!

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Angie

Member since: 05/31/2016

101 Reputation

1 Guide authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 19